Do you know what the lubrication work of a wholesale mixing machine is?

The wholesale mixing machine works in an environment with a lot of ash and sand, so in order to ensure the reliability of the machine and reduce the wear and power loss of the machine parts, lubrication should be done in time, otherwise the ash and other impurities will seriously wear and block the equipment Normal use. Let’s take a look at it with the editor below!
1. The gears and bearings of the Wholesale mixing machine reducer use gear rotation to splash the oil onto the inner wall of the box and flow into the bearings for lubrication. The oil level of the gearbox should be kept between the two engraved lines of the oil dipstick. Too high or too low oil level will cause temperature rise or poor lubrication of all parts, increase power loss and cause machine malfunction. The engine oil should be changed once for the first 150 hours and 300 hours of the new machine in order to remove the dirt that was not completely cleaned during the test run. When working, check the oil level frequently, and make up for the deficiency in time.
2. All exposed parts that need to be adjusted and rotation matching positions should always be kept with lubricating oil. However, the brake belt part must not be contaminated with oil and water, so as not to affect the braking effect.
3. The lubrication of the motor is carried out according to the motor manual.
4. Other lubrication positions and lubrication periods of Wholesale mixing machine shall be carried out according to the lubrication schedule.
Therefore, the above are all important parts in the lubrication process of the Wholesale mixing machine, so when you lubricate the equipment, you must pay more attention to these contents to better complete the lubrication work.